PRODUCT INFORMATION
	Two-teir contoured, channeled diffuser in carbon-fibre. Designed for after-market replacement on Westfields and similar these diffusers extend from the rear bulkhead. This has a three-fold effect reduced drag from the rear fuel tank area which typically acts as a parachute without underfloor covering downforce creation from low pressure area created by aerodynamic profile of the diffuser - increased further as the channels aid the airflow keeping it attached to the contour of the diffuser cleanliness! - covering the underside rear quarter of the car as such helps to keep the dust, mud and much from coating your suspension, diff and fuel tank! Fitting the diffuser will require a small slot cut out at the back of the bodywork (~0.75" x 18") to accomodate the second tier. The diffusers are typically attached at the front by extending the floorpan out an inch or two and 'hooking' the front of the diffuser over this lip. The rear can be attached with tie rods or quick release Dzus clips (not supplied). It is worth bearing in mind that as this diffusers pulls down at speed it is worth spending time ensuring that it is mounted correctly and firmly. When ordering, it is useful if you can pre-measure the length you require (the measurement from your bulkhead to the end of the diffuser) as reduction in this length from the default may reduce the postage cost.	DELIVERY Typical delivery time: 10 days FURTHER INFO Photo gallery Read reviews Ask a question TECHNICAL Dimensional drawings: side, top, end Carbon weaves explained Carbon cutting help Note : Fluke Motorsport Ltd. are in no way affiliated with Caterham Cars & Coachworks Ltd. or Westfield Sportscars Ltd. The components on offer are in no way endorsed by either Caterham Cars & Coachworks Ltd or Westfield Sportscars Ltd.